Dustbin in an above ground of Pentair Water Pool and Spa Dynamo, Pentair pool pump part#354548, removes debris in the water passing through the pump to help avoid that the block they slow water flow. It also eliminates waste to protect the propeller. The basket is not held within the pump housing with a locking mechanism that require the use of special tools. As a result, replacement is simply preparing the pump for the removal of the basket and access to the basket on the pump housing.
Instructions
•Turn off the Pentair Water Pool and Spa Dynamo pool pump.
•Bleed air system to relieve the pressure build-up due to its specific configuration of pump and filter. It's open air pressure bleed valve mount the filter specific pool and wait for the pressure to drop.
•Turn off or disconnect your Dynamo pump from main power supply. Once the pump is not already receiving electricity, close the discharge and suction valves.
•Grasp the clear of the cover over the pump handle and turn counterclockwise to unscrew it from the pump. Lift the lid of the pump housing. Check o-ring (Pentair part #354533) cover for damage. If you see damage, remove it and set it aside for the removal of.
•Grasp the handle of the waste inside the pump basket. Carefully lift the basket up out of the pump housing. Remove the basket.Alsc check intellichlor ic40 best price here.
•Remove the new basket from its packaging. Holding it by the handle, slide vertically into the pump housing. If the system requires a new o-ring, install it at this time. When finished, screw clockwise securely to the pump housing.
•Reconnect the pump power supply. Open valves to fill the pump with water. Turn on the pump.
Tips and warnings
To prolong the life of your pump and basket of trash, clean the basket and check and the o-ring of the damage CAP, at least twice a week.
Always disconnect your Dynamo main power source to prevent the shock or electrocution.
No comments:
Post a Comment