Water circulation in swimming pool inhibits the growth of bacteria and algae, as well as prevents cloudy water to avoid water stagnation. A Pentair pool pump is connected directly to the circular pool PVC pipe water. Pentair pool pump consists of a wet section and engine, each with smaller components all vital for the proper functioning of the pump. A small seal installed in the back of the Pentair pump motor shaft prevents water leakage into the electrical parts of the pump.
Instructions
•Turn off the Pentair pump and disconnect the pool of PVC pipes. If not quickly disconnected or trade unions exist in the Pentair pump, use a saw hacksaw PVC to release the pump.
•Take the bolts installed around the circular flange cover in the middle of the Pentair pump with wrench. Remove the loose sections of the pump and place the wet end holding the basket strainer aside.
•Pull the plastic diffuser Pentair intelllichlor ic40 reviews pump motor shaft to expose the impeller and seal. Tighten to down in the section of the shaft behind the impeller with pliers and hold it still. Turn the impeller counter clockwise until it uwind and leaves the axis, giving easy access to the Board.
•Pull the front piece of the seal of the impeller if it came free with the impeller. Unscrew the mounting of the seal plate holds the seal on the shaft with a screwdriver and remove. Slide the seal part placed in the rear of the axis of.
•Open a new pump seal and do not touch both sides of the seal with their skin face. Body oils damage the integrity of the seals and cause leakage. Carefully the white ceramic portion of seal on the axis of the seat and slide towards the back of the shaft with the White side pointing away from the motor section. Screw the seal plate in place. Set the remaining portion of the seal on the shaft and move to the back of the shaft so that it touches the white part of the ceramic seal face.
•Thread rough the impeller onto the shaft. Hold the shaft with pliers to finish firmly screw the impeller. Ensure the impeller and seal fit comfortably together in the shaft.
• Place the diffuser on the shaft and the motor bolts and ends up wet each other with a key nuts and bolts. Connect the Pentair pump to the pool pipes and connect to a source of power or wall power.
Tips and warnings
Check out the pump seal Pentair monthly to prevent pump problems and prolong the service lifeof the pump.
No comments:
Post a Comment