A Pentair pool chlorinator is a small unit that works with the pump to move the water throughtwo electrolytic cells. These cells break the salt of sodium and chloride, convert common salt tochlorine that cleans the pool. The chlorinator is installed along the pool filtration system andeliminates the need for chlorine packaging be used and stored. To function properly, thechlorinator has to be configured to turn on the pool pump, or moving water and producechlorine.
Instructions
•Turn off the pool filtration system and the pump discharge.
•Select a section of pipe over the return line that is at least 3 feet away from the heater outlet, ifyou have one, or who has about 12 to 18 inches of straight pipe after coming out of the filter.
•Mark this section with the marker.
•Use the brand as a starting point, measure the length of the chlorinator along the pipe. Makeanother mark at the end of this measure. When measuring the chlorinator, measuring only thelinks, not the end pieces that will be within the water lines.
•Cut the pipe along the lines with a hacksaw to remove a section of pipe to the chlorinator.
•Remove the links of the chlorinator and assemble each of the cut ends at the return line usingPVC glue. Let glue dry according to the instructions on the package.
•Insert the chlorinator in the space between the links with the LEDs into the filter of the swimming pool and the "more" buttons and "less" output pointing toward the pool. These buttons adjustthe amount of chlorine produced by the unit.
•Tighten the links in the chlorinator.
•Turn on the pump and look for gas leaks in the pentair chlorinator ic40 best price again, then turn it off. If there is aleak, remove the chlorinator and reinstall fasteners at the ends of the PVC pipe glue, more. They allow that links dried longer than indicated on the container. Cover the entire surface of pipingthat adhere to the Union with glue to ensure a strong hold. Once the glue is dry, reinstall thechlorinator and test again.
• Align the pins of the power cable with the plug in the bottom of the center of power and insertthe cable. Turn the plug until cord is in place.
•Run the cable to the same timer pool pump is in, or have an electrician wire the pump.
No comments:
Post a Comment