The pool pump is a device that is designed to circulate the water in your pool through a filter. Ifyour pool pump does not function properly or is using too much electricity that want to replace itwith a new model, a type of bomb that can be installed is Pentair intellichlor ic40 review You can install a Pentair poolpump by determining first what model of pump that you want to install.
Instructions
•Turn off the power supply to the pool pump. This can be done by turning the switch on theelectric panel of the House.
•Open the access panel for the pool pump if it is in an enclosure.
•Locate the water lines that connect to the pump. Remove the water lines by first loosening theconnections with an adjustable wrench. Turn the key counterclockwise and remove hand.
•Disconnect the power cord of the pool pump. You can then remove the old pool pump and is onone side.
• Place new Pentair pool pump in the same location as the old pool pump.
•Apply sealer of pipe to thread into the nozzle of plastic at the end of the return of the water line.
• Connect the nozzle of the intake port of the pump plastic. Adjust the water line with adjustablewrench.
•Apply PVC pipe cement for the installation of the pipes of water and connect to the pool pump.By sliding them together and twist them slightly to connect water pipes joints.
•Cut the line filter which was connected with the old filter with PCV cutter. Place PVC cutter on the line of the filter and turn the cutter with a ratchet action until the line has been cut.
•Apply PVC glue at the end of the cutting line of the filter and place a new section of pipe. Oneend of the tube is connected to the filter line and the other to the pool pump.
• Connect the power cord to the new pump.
•Turn on the circuit at the circuit breaker panel to complete the project.
Tips and warnings
You should not use a wrench to tighten the fasteners because they can damage the plastic of thepool pump.
No comments:
Post a Comment